A pet business risk assessment needs 1 grid for each service you run.
The hazard most likely to hurt a groomer is rarely the one most likely to hurt a dog walker, so a single list misses half of both. The free risk assessment template that goes with this post has those grids filled in with the usual hazards for grooming, daycare, boarding and walking, and blank rows for yours. This guide walks through how to complete it using the 4 steps in Safe Work Australia's model Code of Practice on managing work health and safety risks.
A note on what this is. We make pet business software and we are not WHS advisers. The steps and rules below come from Safe Work Australia and the state regulators listed at the end. The template is a starting point, and a WHS adviser can check it against your site.
What does WHS law ask a pet business to do?
If you run a business, you are a person conducting a business or undertaking, and you must eliminate or minimise health and safety risks so far as is reasonably practicable. Safe Work Australia's code describes the process in 4 steps (Safe Work Australia):
- Identify hazards: find out what could cause harm.
- Assess risks, if necessary: how serious the harm could be and how likely it is.
- Control risks: put in the most effective control measure that is reasonably practicable and keep it working.
- Review the hazards and controls to make sure they work as planned.
You must also consult the workers who do the work at each step. Under the model WHS laws a worker includes contractors and their employees, apprentices and volunteers. A groomer who rents a table from you runs their own business, and the code expects the 2 of you to consult, cooperate and coordinate on hazards you share.
The model code applies where your state or territory has adopted it, so check with your regulator. Victoria has its own laws and its own regulator, WorkSafe Victoria.
Step 1: How do you find the hazards?
Walk through a whole day, from unlocking to the last pick-up, with the people who work it. Ask what has nearly gone wrong, not only what has. The code asks you to talk to workers about near misses and incidents that were never reported, and to look at your own records.
Your incident reports are the best list you have. If you are not keeping them yet, the dog bite and incident report template gives you one.
These are the hazards the template lists before you add your own:
| Service | Hazards already on the template |
|---|---|
| Grooming | Bites and scratches during handling, lifting dogs onto the table or into the bath, wet floors around the bath, dryer and clipper noise, scissors and blades, shampoos and cleaning chemicals, a dog slipping from the table |
| Daycare | Fights in group play, bites while separating dogs, escapes at gates and doors, heat in the yard, slippery surfaces, cleaning chemicals, lifting dogs and feed |
| Boarding | Bites when moving dogs between pens, escapes during pen changes, hosing and cleaning chemicals, lifting feed and bedding, working alone after hours, fire or power failure overnight |
| Walking | Being pulled over by dogs on lead, off-lead dogs approaching, heat and sun, driving between pick-ups, working alone, entering client homes |
Step 2: How do you rate likelihood and consequence?
The code suggests rating likelihood on 5 levels (Safe Work Australia):
| Likelihood | What it means |
|---|---|
| Certain to occur | Expected to occur in most circumstances |
| Very likely | Will probably occur in most circumstances |
| Possible | Might occur occasionally |
| Unlikely | Could happen at some time |
| Rare | May happen only in exceptional circumstances |
For consequence, the code asks whether a hazard could cause death, serious injury, illness or only minor injuries needing first aid. The template uses those 4 words. Exposure counts too: a risk rises when people meet the hazard more often or for longer, which is why lifting 20 dogs a day sits higher than lifting 2.
You can skip the rating for a known risk with a known control, the code says. Wet floors around a bath are a known risk and a non-slip mat is a known control.
Step 3: Which control should you choose?
The code ranks controls from most to least effective, and you work down the list. Elimination comes first. Then substitution, isolation and engineering. Administrative controls and personal protective equipment come last, because they rely on people remembering, and the code says they should back up a stronger control, cover a short gap, or be a last resort.
| Hazard | Stronger control | Weaker control on its own |
|---|---|---|
| Lifting a large dog into the bath | A walk-in bath with steps or a ramp, or a lifting table | A rule to lift with 2 people |
| Dryer noise | A quieter dryer or sound dampening | Earmuffs |
| Fights in group play | Separate yards by size and temperament | Telling staff to watch closely |
| Escapes at the front door | A double gate, so 1 door is always closed | A sign saying close the gate |
| Harsh cleaning chemicals | A milder product that does the job | Gloves |
| A dog slipping from the table | A table restraint and a non-slip surface | Never leaving the dog alone |
Cost can count when deciding what is reasonably practicable, but the code says it can never be the reason for doing nothing, and it cannot justify relying on behaviour alone when a better control exists. Group size is a control as well: how many dogs a daycare can safely hold covers the capacity side.
A worked example: 1 grooming row, filled in
Coat Club Grooming has 2 groomers and a bather. Most of their Full Groom bookings at $95 to $140 are large breeds, and the bather lifts about 12 dogs a day into a standard tub.
| Hazard | Who could be hurt | Likelihood | Consequence | Controls | Owner | Review date |
|---|---|---|---|---|---|---|
| Lifting dogs into the bath | Bather, groomers | Very likely | Serious injury | Walk-in tub with steps ordered; 2-person lift over 20 kg until it arrives | Owner, Sam | 1 month after the tub is fitted |
The interim control is administrative. The row names the engineering control that replaces it and the date to check it worked.
Step 4: When do you have to review it?
Regularly, and the code lists the moments when a review is required: when a control is not working, before a change that could bring a new risk, when a new hazard turns up, when consultation says a review is needed, and when a health and safety representative asks. Higher risks get reviewed more often.
In a pet business, the changes that should trigger a review are a new service, a new yard or room, a new piece of equipment, a new team member, and every incident or near miss.
Keep the completed assessment. Records show how you made your decisions, and the code points out they help target training at the hazards that matter. Some incidents must also be reported to your regulator straight away: SafeWork NSW lists a death, a serious injury or illness and a dangerous incident, and asks that the scene is left undisturbed except to help the injured person and make it safe (SafeWork NSW). WorkSafe Victoria asks for a call on 13 23 60 and a written report within 48 hours (WorkSafe Victoria).
Where does Petboost fit?
Where we stand. Petboost is our product and we make money when you use it, so weigh this accordingly. The risk assessment itself is a document for your business, and it lives best on paper or in your files, not in booking software.
What Petboost holds is the record that drives step 4. On Fields & Forms, the Incident report team form template is set to When needed, so it is never due: your team adds one on the appointment whenever something happens. It records the type of incident, the severity, where it happened, the team present, injuries, first aid, photos and follow-up, including Review handling notes and Insurer notified. The Fields & Forms page shows how team forms work, and the Petboost Academy lesson Team forms: SOAP notes, daily logs and report cards sets one up.
How to use the template
- Open the risk assessment template and print it or save it as a PDF.
- Fill in the business, site, who completed it and which workers you consulted.
- Cross out the service grids you do not offer, and add your own hazards to the blank rows.
- For each row, rate likelihood and consequence, write the strongest control you can reasonably use, and name an owner.
- Set a review date for each row, sooner for higher risks.
- Have a WHS adviser look over it, then keep it where the team can read it.
Frequently asked questions
Does a small pet business need a written risk assessment?
The duty to manage risks applies to every business, including a sole operator with staff or contractors. Writing it down is the simplest way to show what you identified, what you decided and why, and it gives the next review a starting point.
What is the hierarchy of controls?
The ranking of ways to control a risk, from most to least effective: elimination, then substitution, isolation and engineering, then administrative controls and personal protective equipment. You work down it and use the highest level that is reasonably practicable.
How often should I review my risk assessment?
Regularly, and whenever a control is not working, before a change at the workplace, when a new hazard appears, when consultation shows a need or when a health and safety representative asks. Review higher risks more often.
Do I need to consult my staff?
Yes. The model WHS laws require you to consult workers who are, or are likely to be, directly affected, so far as is reasonably practicable, at each step of the process. That includes contractors working on your premises.
Is a dog bite a WHS hazard?
Yes. A bite to a worker is a work injury, and handling dogs is part of the work in every pet business. It belongs on the risk assessment with its controls, and each bite belongs in an incident report.
Is this template enough to be compliant?
No template can promise that. It is a starting point that follows the steps in the model code. A WHS adviser or your state regulator can tell you what applies to your site.
The printable grids are on the risk assessment template page, and the incident report template is the companion for step 4.
Sources
- Safe Work Australia, Model Code of Practice: How to manage work health and safety risks, published 1 May 2018, last updated 6 November 2026. Accessed 15 November 2026.
- Safe Work Australia, Identify, assess and control hazards. Accessed 15 November 2026.
- SafeWork NSW, Incident notification. Accessed 15 November 2026.
- WorkSafe Victoria, Report an incident. Accessed 15 November 2026.
This is general information, not WHS or legal advice. The worked example is illustrative.